Hey, this is the 8th update on
my SolidWorks blog
This week was the mid semester intensive
and the start of the Lego man assignment.
I stared on the head, as it looked the
easiest and would give me a little bit of practice using the Vernier Calipers
(as I have not used them before).
I started off with extruding the main part
of the head before extruding and cutting the top and bottom. To make the head a
smooth curve I added fillets (the radius was estimated as it was hard to
measure)
I then moved onto the left leg. Getting the
basic shape and cutting out the hollow in the bottom was easy. I then ran into
problems when I was cutting out the circles in the back of the leg. The top one
would not cut out the way I expected/wanted it to. After rechecking the height
on the leg and slightly adjusting it, the cut finally turned out the way it
should look.
Till next time,
Deanna (design student)
Deanna (design student)
No comments:
Post a Comment